On Tue, May 30, 2017 at 5:09 AM, Tor, the Marqueteur Marqueteur@fineartmarquetry.com wrote:

On 29/05/17 16:56, Luke Kenneth Casson Leighton wrote: ...snip...

...

...

1. Am I right that the front right corner actually only needs a single

wide dado on the inside face for the eject button?

yes.

...

2. Do any of the components on the other three corners need cutouts,

no.

...

or are they back just far enough to clear?

yes.

Then, presuming I can find a router bit within tolerance for the height of the eject button, it looks like I could do this design as is for the corners.

if i thin down the parts on the inner edge i could potentially do away with the need for the eject button inset entirely.

i also want to bring out the PCB cut through to the front so that you can do a straight-through cut with a router @ around 1.8 to 2.0mm.

l.