Hi, I remember luke mentioning in the past that injection molding would be too expensive for such a low-volume project. However I found this project from crowd supply that is using molds for production on a total of ~3800 pledges
https://www.crowdsupply.com/ugl/ultimate-hacking-keyboard/updates/2198
The numbers don't make any sense given the ~100k cost luke has mentioned in the past( the 2 keyboard halves have different designs). What am I getting wrong here ? The factory they will be using is located in Europe.
--- crowd-funded eco-conscious hardware: https://www.crowdsupply.com/eoma68
On Sat, Aug 5, 2017 at 12:47 AM, Bill Kontos vkontogpls@gmail.com wrote:
Hi, I remember luke mentioning in the past that injection molding would be too expensive for such a low-volume project. However I found this project from crowd supply that is using molds for production on a total of ~3800 pledges
with half a million dollars, yes.
The numbers don't make any sense given the ~100k cost luke has mentioned in the past( the 2 keyboard halves have different designs).
with only about 4 small part.... not 35.
l.
arm-netbook@lists.phcomp.co.uk