29 Apr
2017
29 Apr
'17
11:42 a.m.
On Sat, Apr 29, 2017 at 6:08 AM, Luke Kenneth Casson Leighton lkcl@lkcl.net wrote:
ok, ouch, onto the fourth revision of the corner-pieces already, and some minor changes to the plywood are needed as well. this really would have been awkward if someone else did it.
the anycubic 3d printer is holding up well. the higher-quality PLA from the company i found on aliexpress seems reasonable so far (the "standard" quality definitely isn't: it literally crumbles under pressure).
i'm going to have to go with 2 bolts through the base to hold the PCB (and the card rails) in place: one isn't enough. assembly's... awkward. it's going to have to go out as a kit.
getting there.
l.