Re: [Arm-netbook] Eoma68 update

On Tue, Jul 25, 2017 at 11:17 AM, Luke Kenneth Casson Leighton lkcl@lkcl.net wrote:

it actually got to be dangerous to try to bend / snap it, i was applying so much force i was concerned that shards might fly off. applying a *lot* of pressure - enough to make marks on my fingers - only bent it about 2-3mm out of shape.

Did you also try some fall tests, because that's more likely to happen in real life. Especially as the case design is not monilithic (if I remember correctly), the shock forces will get applied to the weakest parts.

Hey, it's OK if you actually didn't ;-)

You could test with pieces that had 3d printing problems, so as not to destroy any good ones.

And then label the project as being Eco-consciously tested !