hiya richard, i'd like to send off a test PCB to the factory with just the DC3 micro-hdmi on it, whilst you're happily doing the review, can i ask you the favour of checking to see if there's anything glaringly-obvious about the DC3 layout (just the DC3 footprint really).
i am aware that pins 8 and 12 are so close to the edge of the board (with the 2 VIAs) that it's impossible to get GND shielding round them... and that they're also doing a U-turn 180 degrees which is bad for R.F.... but there's really not a lot of choice here.
at least they're surrounded by GND and vias... and... technically... where the vias come up the pins for those signals are directly above them (also surrounded by pins that are also GND)... so it's kiiinda okay...
thoughts appreciated.
l.