16 Jun
2017
16 Jun
'17
7:03 a.m.
2017-06-16 8:54 GMT+02:00 Luke Kenneth Casson Leighton lkcl@lkcl.net:
On Fri, Jun 16, 2017 at 7:51 AM, mike.valk@gmail.com mike.valk@gmail.com wrote:
. Use smaller width tracks.
can't.
Was afraid of that
. Cut the pads tight a little shorter and place the via's to the right creating a bottleneck but stil far enough from the edge
possible.
. The above but to the left, via's in the middle.
possible but risky.
Depends on how near to can get to left hand pads or the egde on the right and were the pads in the connector have most tolerance.
Speaking of near the edge. The tracks on the board seem awfully close the boards cutoff edge. Doesn't that create a problem for cutting them out?